Lances and Grapers

For my next unit of mounted knights I've changed things a little from previous practice. After re-watching a favourite documentary on the lance I noted the move toward a heavier lance by the time of Lewes and the introduction of the 'graper'. So I decided that I too would follow suite. It was one of those experiments where everything I did just worked. I upped the gauge of my steel wire I make my lances from 1.25mm to 1.57mm - the former being in-shot without the graper. It takes bit more beating when I hammer the ends on my anvil to make the points. When beaten flat they flange or fan out at the ends which I then snip with cutters to make the points. I opt for a broader diamond with my spears but made them much sleeker for a lance. Once filed it was then onto the graper.
 The graper needs to feature more toward the butt end of the lance shaft and was introduced to stop the lance from sliding rearward under the couched arm after impact. It enabled the whole body to take the impact of the contact and drove the lance with greater force inflicting more damage. Of either steel, wood or leather, my miniature versions are of tube aluminium and plastic card. The tubular aluminium is easily cut with a scalpel and the thin plastic card created with an office paper hole punch which was the drilled out to slide over the wire.
The tubular aluminium was a perfect fit; not bad for an out-and-out guess. A couple of drops of Selley's Quick-Fix Supa Glue Gel and I'm done. Perhaps ironic but the next unit of ten knights only has one figure charging his lance ... typical.

Comments

I went the easy option and bought some

Popular posts from this blog

Reserve Ward: Crossbow

William de Goldingham: Research & Modelling

Richard de Grey's Company: Centre Ward Foot